电压差分输入。
四个可调且可调用的内部指令值。
斜坡时间、灵敏度与零点可调。
斜坡时间范围可切换。
“关闭斜坡”输入。
操纵信号输出。
01 | Command value and ramp module | VT-SWMA3-5 |
02 | Component series 10 ... 19 (10 ... 19: unchanged installation and connection dimensions) | 1X |
03 | Version: standard | V0 |
04 | Option: standard | 0 |
01 | 02 | 03 | 04 | |||
VT-SWMA3-5 | \u2012 | 1X | / | V0 | / | 0 |
Component series | 1X | |
Type of electronics | Analog | |
Design | Modul |
Operating voltage | Nominal | UB | V | 24 |
Lower limit value | UB(t)min | V | 18 | |
Upper limit value | UB(t)max | V | 35 | |
Power consumption | PS | VA | 1.2 | |
Current consumption | max. | Imax | A | 0.05 |
Fuse | Electronic fuse protection | |||
Command value | Voltage | Differential input 1) | U | V | \u200b0 \u2026 ±10 |
Input resistance | R | kΩ | 100 |
| 1) | Joint reference potential with actuating signal output |
Enable | On (active) | UF | V | 8.5 ... UB |
Off (inactive) | UF | V | 0 ... 6.5 |
Voltage | Number and designation | 1 (control output) | ||
Voltage | U | V | \u200b0 \u2026 ±10 | |
Setting range | Zero point calibration | % | ± 10 | |
Setting range 1) | Amplitude attenuator for command value | % | 0 ... 110 | |
Setting range 2) | Step-change height | % | 0 ... 50 |
| 1) | Applies to a step level setting of 0 %, separately adjustable for positive and negative signals. |
| 2) | Step level reached at Ucommand = 2 %, separately adjustable for positive and negative signals. |
Command value 1) | "w" | Uw | V | 0 ... ±10 |
| 1) | ±10 V ≙ ±100 % |
LED display | Green 1 | power | |
Green 2 | Enable |
Anschlussart | 6 screw terminals | ||
Mounting type | Top hat rail TH 35-7.5 according to EN 60715 | ||
Protection class according to DIN EN 60529 | IP 20 | ||
Ambient temperature range | ϑ | °C | \u200b0 \u2026 \u200b50 |
Storage temperature range | ϑ | °C | -25 \u2026 \u200b85 |
Weight | m | kg | 0.08 |
Dimensions in mm
Dimensions in mm
与天线线路、无线电设备及雷达系统之间必须保持足够距离（>1 m）。
电磁铁线及信号线不得敷设在动力电缆附近。
对于信号线和电磁铁导线，建议使用屏蔽电缆。
电缆屏蔽层必须尽可能短，并以大面积方式连接至控制柜。
