Major Benefits Of Industrial Hydraulics For Motion Bases

Motion bases for aircraft and other simulators require tight positioning, control long life, quick acceleration high reliability, and deceleration.

The number of people to be moved determines whether or not the motion base will use industrial hydraulic.

Also, the simulators which are used for aircraft rely on hydraulics to hold and raise payloads for a long time and also accelerate and decelerate the payload when elevated.  

There are many application benefits of motion bases which depend on their specific design, motion bases are designed for flight simulation and other related applications.  

However, to know the benefits of industrial hydraulic for your motion bases purchasing industrial hydraulic from a reliable and experienced manufacturer is the most recommended option for the best operation.

The major benefit of industrial hydraulic for motion bases

Overload capacity

Hydraulic motion bases and electric are meant for a particular application and each has plainly defined payload.

If it happens that the payload increases by about 22%, that will cause the electromechanical system to become overload. However, electrical systems depend on the precise sizing of their motors.

However, industrial hydraulic manufacturer hardly oversize these electrical systems, if they do so, it will increase the cost, which may not allow the manufacturer to win the contract.

So, in a case where payload increases the solution is to scrap the old system and buy a bigger and more expensive motion base.

Most importantly, the industrial hydraulic system will accept a wider range of operating parameters that is a well-designed industrial hydraulic system that can be overloaded with about 55% and it will operate more effectively.

Performance

The velocities and acceleration which can be gotten with the hydraulic and electric system are comparable.  

The electromechanical system needs to be skillful for greater resolution because these systems use resolver, encoder, and related feedback transducer.  

 However, industrial hydraulic and electric systems accuracies are similar.

Durability and reliability

Industrial hydraulic for motion bases have been tested to be greater in durability than their electrical counterparts.

Hydraulic for motion bases have been put to use for many years with unchanged hardware in place. Though the computer system and control have been changed and upgraded, the physical parts are still the same.

The development in valves has made industrial hydraulic for motion bases durable and reliable with their functioning surpassing 30 years in utmost cases.

Complexity

Industrial hydraulic system are simple, it has servo valves, actuators, computer, and controller.

The actuators are made to grip the overall system energy during the event of worst happenings and runaways conditions. This can be achieved by applying built-in cushions at the end of the actuator stroke.

The common design is made into the cylinder to protect it from electrical, all control, and hydraulic faults.

Maintenance

The industrial hydraulic system needs to be checked every 1000 hours of operation. To maintain it, you need to check and replace filters, take fluid samples, run a diagnostic test, and do general maintenance to ascertain everything is in proper shape.

Conclusion

There are many benefits of industrial hydraulic for motion bases; these benefits are what make motion bases work in aircraft and other simulators.

The benefits range from maintenance, performance, durability and reliability, complexity, and overload capacity.

Other benefits include size and power requirements, installation noise and safety, etc all these benefits are what make hydraulic works effectively most especially in motion bases and other simulators.

However, when the need arises to get a hydraulic system for your motion bases or other simulators purchasing from a reliable and experienced industrial hydraulic manufacturer is the most recommended option for your operations.